Фактическая температура воздуха в Находке on-line. Прогноз погоды в Находке  

Z-travel on Shapeoko 2

Z-travel on Shapeoko 2

Сообщение kesizewi » Пт мар 09, 2018 8:48 pm


I've got my Shapeoko 2 assembled and working correctly (I think). I was able to attach a Sharpie and do the "Shapeoko 2" print after a few wiring corrections. I was trying to mount the rotary tool on the Z-axis and after finally getting it mounted I've found that design keeps it from having much travel at all. It hits the top of the spindle assembly almost immediately. What I was thinking was maybe adding a 1/2" block of aluminum between the clamps and the spindle base would be a good idea for better clearance. Would this work or is there some reason to keep the spindle as close to the X rails as possible?

please help

I did not find the right solution from the internet.

https://www.shapeoko.com/forum/viewtopi ... =10&t=2597
Custom explainer video service

Сообщения: 6
Зарегистрирован: Ср янв 24, 2018 4:03 pm

Кто сейчас на конференции

Сейчас этот форум просматривают: нет зарегистрированных пользователей и гости: 1